Pilz PNOZ m1p base unit Manuel d'utilisateur télécharger pdf (Page 22)

Commissioning

Operating Manual PNOZ m1p (ETH)

20878-EN-12

Download modified project to the control system PNOZmulti

Load modified project from chip card

To download data via chip card, the existing configuration data must first be deleted (gener-

al reset of device).

Procedure:

} Switch off the supply voltage.

} Disconnect all the output terminals.

} Jumper OA0-I19 on the base unit.

} Switch on the supply voltage.

When the "DIAG" LED on the base unit flashes, the memory has been cleared. The project

data can now be downloaded:

} Switch off the supply voltage.

} Remove the old chip card from the chip card slot on the base unit.

} Remove the jumper from OA0-I19 on the base unit.

} Insert the chip card containing the current project into the card slot.

} Switch on the supply voltage.

Load modified project via integrated interface

Proceed as described for the initial commissioning

Connection

Supply voltage AC DC

For the safety system

(connector X7)









For the semiconductor outputs

(connector X2)

Must always be present, even if

the semiconductor outputs are not

used







Supply voltage

6.3.3

6.3.3.1

6.3.3.2

6.3.4

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Pas de commentaire

Pilz PNOZ m1p base unit Manuel d'utilisateur Page 22