Pilz PNOZ mc2.1p EtherCAT 2 Manuel d'utilisateur télécharger pdf (Page 19)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

6-1

6.1 General wiring guidelines

6 Commissioning

66000CommissioningCommissioning6-6.1General wiring guidelines6100General wiring guidelines6-Verdrahtung_PNOZ mc2p

The wiring is defined in the circuit diagram of the PNOZmulti Configura-

tor.

It is possible to define which inputs and outputs on the safety system will

communicate with EtherCAT.

Note:

 Information given in the "Technical details" must be followed.

 Use copper wire that can withstand 75 °C.

Please note the following when connecting to EtherCAT:

 The following minimum requirements of the connection cable and

connector must be met:

– Only use standard industrial Ethernet cable and connectors.

– Only use double-shielded twisted pair cable and shielded RJ45

connectors (industrial connectors).

– 100BaseTX cable in accordance with the Ethernet standard (min.

Category 5)

 Measures to protect against interference:

Ensure the requirements for the industrial use of EtherCAT are met,

as stated in the Installation Manual published by the User Group.

Verdrahtung_multi_Achtung_Kabel_spannungsl_ziehen_Modul

CAUTION!

Only connect and disconnect the expansion module when the

supply voltage is switched off.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26 27

Pas de commentaire

Pilz PNOZ mc2.1p EtherCAT 2 Manuel d'utilisateur Page 19