Pilz PNOZ s2 C 24VDC 3 n/o 1 n/c Manuel d'utilisateur télécharger pdf (Page 9)

PNOZ s2

Operating Manual PNOZ s2

21394-EN-07

Reset

Fault

Diagnostics: Position of rotary switch is not permitted or rotary switch was ad-

justed during operation.

} Remedy: Switch supply voltage off and then on again.

Power, In1, In2, Out, Reset, Fault

Diagnostics: The operating mode selector switch "mode" is in its start position

(vertical position)

} Remedy: Switch off the supply voltage and set the required operating mode

on operating mode selector switch "mode".

Faults - malfunctions

} Contact malfunctions: If the contacts have welded, reactivation will not be possible after

the input circuit has opened.

Service life graph

The service life graphs indicate the number of cycles from which failures due to wear must

be expected. The wear is mainly caused by the electrical load; the mechanical load is negli-

gible.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Pilz PNOZ s2 C 24VDC 3 n/o 1 n/c Manuel d'utilisateur Page 9