Pilz ST SB DP S, SW paket PROFIBUS-DP Manuel d'utilisateur télécharger pdf (Page 6)

Introduction

1-2 PROFIBUS-DP-Slave Operating Manual

4 Setting parameters

This chapter describes the parameters, diagnostics and the

configuration of input and output data.

5 Commissioning

This chapter describes the commissioning procedure.

6 Standard function blocks

This chapter provides information on the parameters and

management of standard function block SB 230.

7 Appendix

The example is designed to provide support when linking standard

function block SB 230 into a user program.

Terminology

• The term "safety system", "system" or "PSS" will be used in this manual

to refer to the programmable control systems PSS. If the description is

only valid for a particular device, the specific product name will be used

(e.g. PSS SB 3006 DP-S, PSS(1) DP-S).

• In this manual, data transfer is always regarded as viewed from the PSS:

input data / receive data is sent from a PROFIBUS subscriber to the

PSS. Output data / send data is sent from the PSS to a PROFIBUS

subscriber.

1 2 3 4 5 6 7 8 9 10 11 ... 42 43

Pas de commentaire

Pilz ST SB DP S, SW paket PROFIBUS-DP Manuel d'utilisateur Page 6