Pilz PSENvip RL D P Manuel d'utilisateur télécharger pdf (Page 100)

7.3 Adjustment during tool change

7 Commissioning

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

7-16

Assignment to a tool class depends on

 Compliance with the requirement from EN 12622, whereby the pro-

tected field must safeguard areas lying 15 mm before the front bend-

ing line.

 Full or partial detection of the upper tool via the protected field.

Fig. 7-13: Classification of tools into tool classes

Tool class 1

 The contour of these tools is fully detected by the PSENvip.

 The front (V1 or B1) and rear (H1 or B1) bending lines are within the

protected field.

 The front segments of the protected field are at least 15 mm away

from the front bending line.

 These tools are safeguarded in compliance with the standards.

 Example:

Fig. 7-14: Example for tool class 1

>15 mm

<15 mm

H3 V2H2 V3V1H1 B1

max. 32 mm

max. 25 mm

> 15 mm

HHVV

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 156 157

Pas de commentaire

Pilz PSENvip RL D P Manuel d'utilisateur Page 100