Pilz PSENvip RL D P Manuel d'utilisateur télécharger pdf (Page 71)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

5-3

5.2 Install transmitter and receiver

5 Installation

 Both the transmitter and receiver are installed in the same way. Only

the dimensions of the adjustment plates for the transmitter and re-

ceiver are different.

To install the system, proceed as follows:

 Fasten the adjustment plate as shown in the diagram below. Ensure

that the flat washers, spring washers and nuts are attached in the

right order.

Fig. 5-2: Installing the transmitter and receiver

Viewed from the operator's side, the receiver is installed on the left-hand

bracket and the transmitter on the right-hand bracket.

 Slide the nut slot on the adjustment plate into the groove on the

bracket attached to the upper die.

Nut

Auxiliary adjustment plate

Adjustment plate

Flat washer

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 156 157

Pas de commentaire

Pilz PSENvip RL D P Manuel d'utilisateur Page 71