Pilz PSENvip RL D P Manuel d'utilisateur télécharger pdf (Page 112)

7.6 Check protective equipment

7 Commissioning

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

7-28

7.6.1.5 Function test using the test piece

Function test using the test piece7-Inbetriebnahme_Schutzeinrichtung_pruefen_Funjktionspruefung_mit_Pruefkoerper

Function test using the test rod (= test piece handle)

 Move the test rod (14 mm diameter) slowly along the whole detection

zone at the centre point of the upper tool.

Fig. 7-22: Function test using test rod

The test rod must be detected along the whole length of the detection

zone.

The OSSDs switch to the OFF state. The LED on the receiver lights up

red.

INFORMATION

The following tests must be run on the left- and right-hand end

as well as in the centre of the press brake:

- During initial commissioning: 10 times

- During the daily check and during a tool change: 3 times

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 156 157

Pas de commentaire

Pilz PSENvip RL D P Manuel d'utilisateur Page 112